DTS FOS 100 SOLO ON-OFF WHITE 36, Руководство пользователя

Страница: 16 / 28

7- DMX SIGNAL CONNECTION
FOS 100 SOLO IP65 WHITE 36 (on request)
The unit operates using a digital DMX 512 signal. Connection between the controller and the unit or
between units must be carried out using a two pair screened ø 0.5 mm.
P.S:
If the display showing the DMX address flashes, then one of the following errors has occurred:
- DMX signal not present
- DMX reception problem
For Installations where long distance DMX cable connections are needed, we suggest to use a DMX
terminator.
The DMX terminator is a male DMX cable connector with a 120 ohm resistor Between pin 2 and 3.
The DMX terminator must be plugged into the DMX out panel connector of the last unit connected to
the DMX line.
Ensure that the conductors do not touch each other. Do not connect the cable ground to the DMX
connector chassis. The plug housing must be isolated. Connect the mixer signal to the DMX IN projector
plug and connect it to the next projector by connecting the DMX OUT plug on the first unit to the DMX
IN plug of the second one.
In this way, all the projectors are cascade connected.
PLACE A 120 OHM RESISTOR BETWEEN PIN 2
AND 3 OF A MALE DMX CONNECTOR AND PLUG IT
INTO THE DMX OUT PANEL CONNECTOR OF THE
LAST UNIT CONNECTED TO THE DMX LINE
MALE CABLE
CONNECTOR
DMX
120 OHM
DMX OUT DMX OUT DMX IN DMX IN DMX OUT DMX OUT DMX IN DMX IN
5
3
4 2
1
1=GND
2=DATA-
3=DATA+
CONTROLLER
S T A N D A R D
D M X 5 1 2
FOS 100 WHITE 36 15