CHANGINGTHE RADIOCHANNELOFTRANSMITTER - RECEIVERCOMMUNICATION
The set communicates with each other on one of three frequencies. In the case of work in the vicinity
of several sets of transmitter - receiver, for operational reliability, it is recommended to set a different
radio channel for communication between the transmitter and the receiver in each set.
To change the radio channel:
- press and hold the button on the AZ-TX transmitter, release the button when the "ST" LED starts
blinking,
- the "ST" diode generates 1, 2 or 3 pulses, simultaneously indicating the number of the radio channel
that is currently used,
- briefly press the button on theAZ-TX transmitter to change the radio channel,
- press and hold the button on the AZ-TX transmitter to confirm the channel selection.The diode will
blink, signifying the success of the operation,
- in the same way, change the radio channel in the AZ-FLEXRX receiver module installed in the FLEX
receiver.
The channels set in the AZ-FLEXRX module and in the AZ-TX transmitter must be
identical.
FORMATOFTHEAZ-FLEXRX RECEIVING MODULE
To format the AZ-FLEXRX module, press and hold the button for 15 seconds. The diode will first
display the channel number currently set and then it will blink and go off. The button should be
released after the diode goes out.
Formatting the module causes:
- removing the transmitter from memory,
- restoration of radio channel No. 1.
PACKAGECONTENTS
-AZ-TX transmitter
-AZ-FLEXRX receiving module
-AZ-MG magnet
- 3.6V / 8.5Ah battery, typeC
- set of 4 mounting pins
- Installation and operating instructions
