SENSOR LAUNCH
After mounting the transmitter and magnet on the gate, it is necessary to calibrate the AZ-TX
transmitter and pair it with theAZ-FLEXRX receiving module in the FLEX receiver.
1.Calibration of theAZ-TX transmitter
- close the gate
- briefly press the transmitter button - the "ST" LED will flash
- open and close the gate once
- press the AZ-TX transmitter button again shortly - the "ST" LED will blink rapidly indicating the
success of the operation.
If the "ST" LED generates 2 pulses, the calibration procedure failed. The reason may be
too much distance between the AZ-MG magnet and the AZ-TX transmitter or too small
difference in the open and closed distance. Correct the assembly and repeat the
calibration procedure.
2. Pairing the transmitter with the FLEX receiver
- press the button on theAZ-FLEXRX module in the FLEX receiver - the diode will start to flash,
-open and close the gate - the diode will start to blink rapidly indicating the success of the operation.
Pairing can take place a few seconds after the opening of the gate.
3.Control of the sensor's operation.
When the gate is closed, the LED in the AZ-FLEXRX module in the FLEX receiver should be on. When
the gate is not closed, the LED should be off.
If the diode in the AZ-FLEXRX module blinks shortly every 5 seconds, it indicates a weak
battery in theAZ-TX transmitter paired with it.
If the diode in the AZ-TX transmitter generates 5 pulses, it may mean a low battery or
damage of the transmitter. Replace the battery. If the problem recurs despite the battery
replacement, please send the device for service.
PRESENTATIONOFTHEGATE STATE
Appropriate mounting of the AZYMUT sensor allows you to check the gate state on a mobile device
or computer.
The status of the gate is visible after adding a FLEX receiver, equipped with an WL card, to the
CloudFlex account (www.cloudflex.dtm.pl), and in the V-PILOT mobile application available for
Android and iOS devices.
There is a version of the Azymut sensor equipped with a Bluetooth module. The producer provides
the API for further implementation in order to connect to the device from the external application
level.
