I. Terms in use
II. General informations
III. Technical data
IV. Receiver installation
4
4
4
Monostable output mode – turn on for programmed time after pushing the button
Bistable output mode – turn mode to opposite (turn on or turn off) after pushing button
Momentary output mode – turn on as long as the button is being pushed
dynamically variable code Keeloq gives high class safety
superherterodine receiver, work frequency: 433.92 Mhz
reciver's memory containing 35 ZSP series remotes (NEO, TIP)
two separated NO relay outputs, working in mono-, bistable or momentary mode, max load for each output 1A/24V AC or
DC
turn on time in monostable mode: from 0,5 sec and from 1 sec to 127 sec, bistable mode remembers last state before
power down
simple remote registering without need of using receivers buttons
possibility to lock easy remote registering function
discretion with ascribing remote buttons to receivers outputs
terminal block to switch aerial's concentric cable
splash – proof case IP-53
receiver suppy from 12 V to 24 V AC/DC
max current constription:1005mA (with two channels on and 24 V supply)
dimension: enclosure [mm] heigh 118, width 55, depth 27,5
working temperatures from -20° C to +55° C
Strub aerial of 170 mm length is switched to aerial block in new receiver. To enhance radio range use outdoor aerial.
Outdoor aerial's concentric cable need to be switched to Y marked terminal block and ground marked terminal block.
4
4
4
4
4
4
4
4
4
4
4
4
4
4
Rival 432 receiver is one of remote control and access control devices that build ZSP System. Basic application of
ZSP System is to work with controllers of gate, rollers, also lightning, alarm system (direct connection to alarm line or
switchboard) and direct contol of devices such as entryphone, intercome, etc. as well.
Thanks to new, full programed functions, Rival 432 receiver come up to clients expectations. New
and possibility of programming
increase product values.
Rival 432 receiver contains of main board, the splash – proof case and aerial . Main board (fig.1) has
microprocessor control system of LED diodes and buttons, executive set on two relays, connectors of supply,connectors of
outside antenna and controled devices.
neighbourhood of the energetic devices and metal elements will short the range
radio interferance from other sources will short the range
avoid wet and concrete walls for mounting the receiver
remember to remove old used batteries from remotes
mount the receiver's as high as possible
use the good quality coaxial cable for making the outdoor aerial
simplify programming
interface
more remote controls
Hints for making the radio range optimal:
-
-
-
-
-
-
1. Device description and installation
1
1
ZSP Rival 432
A radio receiver operating manual
2
1
3
4
MADE IN
POLAND
