DTM System POMENA, Руководство пользователя

Страница: 8 / 12

8
EN
5. ELECTRICAL CONNECTION
The lamp can operate with most of the gate controllers on the market.
POMENA 230, POMENA 230B must be connected to the controller output designed for 230V lamp.
POMENA 24, POMENA 24B must be connected to the controller output designed for 24V lamp.
If gate controller does not have a built-breaker, it can be run through appropriate setting of the
jumper in the lamp (Fig. 3).
6. ANTENNA CONNECTION
Electrical connections should be made in accordance with the instructions of the device to which
the antenna will be connected. Use 50Ω coaxial cable to connect the antenna. Connect the coaxial
cable to the terminal marked with the symbol Y (center wire) and to the terminal marked GND. The
preparation of the antenna cable is shown in Fig. 4.
CONTINUOUS MODE
PULSE MODE
power
0.5 0.5 s.
power
Fig. 3 Operation mode
configuration.
Fig. 4 Preparation
of the antenna wire.
6,5mm
3,5mm Fig. 1 Electrical diagram
of POMENA 230, POMENA 230 B
connection to the automation
controller.
gate controller
OUT lamp
230V AC
INPUT
antenna
OUT lamp
24V AC/DC
INPUT
antenna
ANTENNA WIRE
Fig. 2 Electrical diagram
of POMENA 24, POMENA 24 B
connection to the automation
controller.
gate controller