DTM System MEMO, Руководство пользователя

Страница: 6 / 19

In the receiver's memory, remotes / numbers from the file set in the MEMO MANAGER program as the
main one are first entered (see the MEMO MANAGER instruction).
If no file is set as the main one, the MEMO programmer will use the remotes / numbers file with the highest
number for saving, i.e. the file of recently remembered remotes / numbers.
It is possible to skip the main file and select the most recent remotes / numbers to save the file.
The procedure can be used for simple transfer of remote control memory / numbers between
receivers.
In order to enter to the receiver the last saved remotes / numbers and configuration of the GSM receiver,
bypassing the main file, you should:
ź
connect the MEMO programmer to the receiver. The BACKUP, WRITE and UPDATE indicator LEDs will
begin to flash to indicate that the programmer is ready for operation.
ź
press and hold the WRITE button for more than 3 seconds.
ź
release the WRITE button when the red WRITE LED goes off. MEMO will first create an emergency
backup of the receiver's memory. It is signaled by a fast pulsing of the green BACKUP diode and lighting of
the red WRITE diode. Then the process of saving the remote controls to the receiver's memory will start.
This is indicated by the green BACKUP diode going off and the red WRITE diode pulsing. The end of the
recording is signaled by the blinking of the BACKUP, WRITE and UPDATE LEDs.
When entering remote controls / numbers from a file, do not disconnect the MEMO
programmer from the receiver.
If errors occurred during the recording, the red WRITE diode will flash cyclically to indicate the error code
(see item 6).
1
CONNECT MEMO TO
RECEIVER VIA USB CABLE
868 433
PWR
C1
C2
MOM
MONO
BIST
G/LOCK
7 ALL LEDS BLINK
RECORDING TO RECEIVER
COMPLETED
3
HOLD THE WRITE BUTTON
UNTIL THE LED TURNS OFF
2 ALL LEDS BLINK
PUSH AND HOLD
WRITE BUTTON
6 WRITE LED BLINKS
RECORDING TO RECEIVER
fIG. 4. Recording of remotes / numbers and configuration of the GSM receiver using the last created file.
4 RELEASE THE WRITE
BUTTON WHEN THE LED
TURNS OFF
5
BACKUP LED BLINKS
WRITE LED ON
RECORDING AUTOBACK.RRF
6