DTM System BLUE 232, Руководство пользователя

Страница: 7 / 16

3.3. Description of the electrical connections of the BLUE 232 controller
Connection to the 230VAC electrical network may only be performed by a qualified specialist with
appropriate authorizations. The delivered controller is immediately ready for operation. Connect all
installed additional protection and control devices to the appropriate terminals in accordance with the
connection diagrams.
3.3.1. Mains supply terminals 230VAC, 50Hz (L, N, PE)
This connector is intended to connect the controller power supply from the 230VAC, 50Hz mains.
The power supply circuit to which the controller will be connected should be equipped with a switch that
cuts off the power supply to the control board. As a standard, the phase conductor is connected to the L
terminal, the neutral conductor to the N terminal, and the protective conductor (yellow-green) to the PE
terminal.
3.3.2. Terminals for connecting the MOTOR 1 and MOTOR 2 actuators (PE, OPEN, COM,
CLOSE)
The actuator that opens first (important when the leaves close "overlap") should be connected to
the MOTOR1 terminals. The second actuator should be connected to the MOTOR2 terminals. Connect
the actuator's opening wire to the OPEN terminal, the closing wire to the CLOSE terminal, the common
wire to the COM terminal and the actuator's protective wire to the PE terminal.
3.3.3. Terminals for connection of CAP1 and CAP2 motor capacitors
Motor capacitors, appropriate for the given type of actuators, should be connected to CAP1 and
CAP2 connectors.
3.3.4. Terminals for connecting a 24V / 6W signal lamp
Clamps are used to connect a 24V LED lamp with a maximum power of 6W. Connect it to the
LAMP and + 24V terminals (fig. 2.). In the case of a lamp with a built-in interrupter, turn off the interrupter
function in the controller.
3.3.5. Clamps for connecting the gate bolt ( )
The controller is equipped with an output that can control the 12 / 24V DC gate bolt. Remember
about the maximum load capacity of the accessory power output, 0.5A in total.
3.3.6. Additional output terminals (OUT C)
The controller is equipped with a relay with leaded NO contacts with a maximum load capacity of
30VAC / DC 1A, enabling the control of an additional device, such as an electrolock, additional controller,
lighting (using an additional relay with an appropriate load capacity), etc. The output is switched on with
the OPEN C manual control button or button on the remote control.
3.3.7. Accessory power supply terminals (+ 24VDC)
The controller has a 24VDC accessory power supply output, max. 0.5A. The output has two
equal screw terminals with a ground potential (0V) and a potential of + 24V.
230V AC
50 Hz
PROTECTIVE CONDUCT
OR
NEUTRAL
PHASE
L N PE
Mains
supply
terminals
capacitor M1 capacitor M2
L N PE
OPEN COMCLOSE PE PE CLOSE COM OPEN
MOTOR 2
MOTOR 1 CAP 1
CAP 2 PE N L
YELLOW - GREEN*
BROWN*
BLACK*
GRA
Y*
M2
right actuator*
230VAC
max.350W
M1
YELLOW - GREEN*
GRA
Y*
BLACK*
BROWN*
left actuator*
230VAC
max.350W
Figure 3. View of the terminals for connecting
the controller power supply and connecting
the motors with capacitors.
Electrical connections
7
* referst to the DTM300/400/600 actuators