DTK PRM-0084I VBX, Руководство пользователя

Страница: 40 / 55

Award BIOS Setup Guide
35
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master PIO/IDE
Secondary Slave PIO: Available selection are “Auto”, “Mode 0”, “Mode 1”, “Mode 2”, “Mode
3” and “Mode 4”. To choose “Auto”, the system BIOS will scan the IDE device and decide
which mode of the device is . Otherwise the user should key in the mode of the device to the
corresponding field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
IDE Primary Master UDMA/IDE Primary Slave UDMA/IDE Secondary Master
UDMA/IDE Secondary Slave UDMA: Available selection are “Auto” or “Disabled”. To
choose “Auto”, the system BIOS will scan the IDE device and decide Ultra DMA supported or
not.
Init Display First: Enabled to let the system initialize the AGP display first prior to the other
display adaptor.
Power On Function: This item is used to set the system power on method. The settings are
Button Only, Password, Hot Key, Mouse Left or Mouse Right.
Onboard FDC Controller: Choose Enabled or Disabled. “Enabled” allows onboard Floppy
Drive Controller to be functioned, otherwise the users should use other sources..
Onboard Serial Port 1: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choosing proper I/O Address/IRQ, be sure not to cause Address conflict with
other I/O devices. The default setting is 3F8/IRQ4.
Onboard Serial Port 2: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choose proper I/O Address/IRQ, be sure not to cause Address conflict with
other I/O devices. The default setting is 2F8/IRQ3.
UART Mode Select: Choose Standard, ASKIR (Amplitude Shift Keyed Infrared Port), IrDA 1.0
for serial Interface.
RxD, TxD Active: The available options are “Hi, Hi”, “Hi, Lo”, “Lo, Hi” and “Lo, Lo”. It is
used to configure the logic level of Receive and Transmit signal in IrDA interface.
Onboard Parallel Port: Choose None or with four different I/O Address and corresponding
IRQx. While choosing proper I/O Address, be sure not to cause Address conflict with other I/O
devices.
Parallel Port Mode: Choose Normal, SPP, ECP, ECP+EPP(1.9) and ECP+EPP(1.7) Mode.
Make proper selection with the attached printer port device.
ECP Mode Use DMA: Choose “1” or “3” to select the DMA channel used for the ECP device.
This item is shown if the Onboard Parallel Mode is chosen as “ECP” or “ECP/EPP” option.