DTK PAM-0066I, Руководство пользователя

Страница: 48 / 67

Chapter 4
42
IDE Primary Master UDMA/IDE Primary Slave UDMA/IDE Secondary Master
UDMA/IDE Secondary Slave UDMA:
Available selection are “Auto” or “Disabled”. To
choose “Auto”, the system BIOS will scan the IDE device and decide Ultra DMA supported or not.
On-Chip Primary/Secondary PCI IDE: This item is used to set the onboard IDE controller. The
settings are Primary, Secondary, Both or Disabled. The default setting is Both.
USB Keyboard Support: Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
Onboard FDD Controller: Choose Enabled or Disabled. “Enabled” allows onboard Floppy Drive
Controller to be functioned, otherwise the users should use other sources..
Onboard Serial Port 1: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
While choosing proper I/O Address/IRQ, be sure not to cause Address conflict with other I/O
devices. The default setting is 3F8/IRQ4.
Onboard Serial Port 2: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
While choosing proper I/O Address/IRQ, be sure not to cause Address conflict with other I/O
device. The default setting is 2F8/IRQ3.
Onboard IR Controller: Choose Enabled to enable the IrDA/ASKIR function.
IR Address Select: This option provide six different address for IR. The options are “3F8H”,
“2F8H”, “3E8H”, “2E8H”, “3EH” and “2E0H”.
IR Mode: Choose ASKIR (Amplitude Shift Keyed Infrared Port) or IrDA for serial Interface.
IR IRQ Select: This option provides four IRQ line for the IR function. The options are IRQ3,
IRQ4, IRQ10 and IRQ11.
Onboard Parallel Port: Choose None or with four different I/O Address and corresponding
IRQx. While choosing proper I/O Address, be sure not to cause Address conflict with other I/O
devices.
Parallel Port Mode: Choose SPP, EPP, ECP, ECP+EPP Mode. Make proper selection with the
attached printer port device.
ECP Mode Use DMA: Choose “1” or “3” to select the DMA channel used for the ECP device.
This item is shown if the Onboard Parallel Mode is chosen as “ECP” or “ECP/EPP” option.
ECP Mode Select: Choose “EPP1.7” or “EPP1.9”, which is used to configure the EPP using
either EPP1.7 or 1.9 timing specification. This item is shown if the Parallel Mode is chosen as
“EPP” or “ECP+EPP” option.