DTE S6 LED, Инструкция по эксплуатации, Страница: 12 / 19

10
[Note 3 ] If the scaling tip has been screwed on tightly and there is fine spray too, the following phenomena show that the scaling tip is damaged:
a) The vibrating intensity and the pulverization degree become weak obviously.
b) During operating, there is some buzz when the scaling tip is working.
[Note 4] If the power cable connected to the grid electricity end of the power adapter is damaged, as the power cable is not removable, for your
safety, please contact a professional for replacement.
4. Precaution
4.1 Usage notice
4.1.1The use of the product must comply with the relevant regulatory requirements of the medical regulatory authorities, and should only be
used by trained doctors or technicians.
4.1.2 Keep the scaler clean before and after operation.
4.1.3 The scaling tip, wrench and handpiece must be sterilized before each treatment.
4.1.4 Don't screw the scaling tip when stepping on the foot switch.
4.1.5 The scaling tip must be fastened. There must be fine spray coming out from the tip when operating.
4.1.6 Change a new one when the tip is damaged or worn excessively.
4.1.7 Don't twist or rub the tip.
4.1.8 While scaler working, the heat of scaling tip will become higher if there is no water flowing out. Please keep the water flow smoothly.
4.1.9 Don't use impure water source, and be sure not to use normal saline instead of pure water source.
4.1.10 If use the water source without hydraulic pressure, the water surface should be one meter higher than the head of the patient.
4.1.11 Don't knock or rub the handpiece.
4.1.12 Please put the power plug into the socket easy to pull out, to make sure it can be pull out in emergency.
4.1.13 When using the equipment, please keep the water get through smoothly, otherwise patient's tooth surface would be injured by overheat in
the handpiece.
4.1.14 After operating, turn off electrical source, and then pull out the plug of power adapter.
4.1.15 As a professional manufacturer of medical instruments, we are only responsible for the safety on the following conditions:
I.The maintenance, repair and modification are made by the manufacturer or the authorized dealer.
II. The changed components are original of "DTE" and operated correctly according to instruction manual.
III. Maintenance is forbidden while the device is used for treatment.
4.1.16 The screw thread of the scaling tips produced by other manufacturers maybe coarse, rusty and collapsed, which will damage the screw
thread of the handpiece irretrievably. Please use "WOODPECKER" brand scaling tip.
4.1.17 Please select a suitable power when using different type of tips (refer to "TABLE OF OPERATING POWER OF THE TIPS").