SPLINE
®
Wheels - Technical Manual
20
Con
vert
ing t
h
e
Hu
b [
S
cre
w
e
d
on
En
d Ca
ps]
V2
01
6.
0
5
Putting on the End Caps
9.
Check the bearing.
The hub must turn smoothly.
The hub must not have axial play.
10.
If necessary tap in the bearing on the non disc side
or loosen the bearing.
11.
Repeat previous steps until the hub is turning
smoothly.
1.
Grease the bearings and the inner surface of both
end caps (fig. 3-1/1).
2.
Screw on both end caps (fig. 3-1/1) by hand.
3.
Tighten the end cap (fig. 3-1/1) with 15 Nm using a
wrench.
20 mm, 15 mm und 9 mm end caps: 22 mm
open-end wrench
QR end caps: 5 mm Allen key
Closing Steps
Link
Mount the brake disc.
see instructions of the manufacturer
