DT509
ENGLISH
2
3
ENGLISH
Precau
ti
ons
Always exercise care when opera
ti
ng and handling the DT509.
•
Never disassemble any por
ti
on of the enclosure, as this will void any product warranty on the
•
DT509.
Do not use any AC/DC adapter other than the one provided with the device or a replacement
•
acquired from the manufacturer.
In the unlikely event that smoke, abnormal noise or strange odor is present, immediately power
•
down the DT509 and disconnect all power sources. Please report the problem to your device
provider immediately.
Basic Features
The DT509 integrates a bright and responsive touch display, two USB ports, and is complemented
by a suite of op
ti
ons including a magne
ti
c stripe reader (MSR), 2D barcode scanner, RFID reader,
presence sensor and scanner auto-detec
ti
on for comprehensive point-of-service applica
ti
ons.
Powering ON and OFF
The DT509 is programmed to Power On automa
ti
cally when power is
fi
rst applied or re-established.
To turn o
ff
the device, use the so
ft
ware shutdown interface provided, or unplug the device.
In the event of system lockup, unplug and then re-plug the power cable.
Calibra
ti
on
The touch display for the DT509 is calibrated before shipping. In the event that the calibra
ti
on has
been modi
fi
ed or is unsa
ti
sfactory, the respec
ti
ve calibra
ti
on rou
ti
nes (e.g., PenMount (PM) for
Windows XP) to calibrate the touch interface may be used. Such applica
ti
ons are typically executed
through touch input via Stylus or through mouse click via a USB mouse.
I/O Panels
The DT509 has a comprehensive set of I/O ports. The following ports are located along the lower
rear edge of the display unit.
Op
ti
ons
The DT509 has a number of op
ti
onal modules. These include:
Magne
ti
c stripe reader (MSR)
•
Presence sensor and scanner auto detec
ti
on
•
2D barcode scanner
•
RFID reader
•
Wi-Fi networking
•
A
A
B
B
C
C
D
D
E
E
Mic and line-out jacks
USB ports x 2
Ethernet port
DC-in jack (AC/ DC)
Phoenix connecter (DC/ DC)
