5
OPERATION
Control:
Stick / Wheel / Switch Position 2P / 3P Switch.
LED L8 is permanently ON when the switch is switched ON.
ACOUSTIC SIGNALLING
Connect the KPX1 piezo buzzer instead of the
LED L2B. Set the blinking L2 while reversing
and the siren will beep intermittently.
After turning the model on the LEDs will blink and then respond to
control respectively.
Switching ON by LED switch S1
: set switch S1 to the OFF (the LEDs
are switched ON by OFF the switch).
Switching ON the LED with 3P switch
(on the transmitter) and LED L8
control. In the
down
position, all LEDs are OFF. In the
middle
position, L1 to L7 are ON (depending ON the setting), L8 is OFF.
Switching from middle to
upper
position turns ON
L8 (reflector)
.
Hazard blinkers LED L5 and L6:
first moving wheel from straight to
left and back you turn ON blinking LEDs, second turn ON 2x flashing
LEDs, third turn OFF LEDs, other turn ON blinking LEDs etc.
LED L7:
first moving wheel from
straight to right and
Footlights
back
you turn ON LED L7, second turn ON blinking L7, third turn OFF
L7, other turn ON L7 etc.
Switched on L5, L6, L7
can only be switched
OFF
when the stick is in
neutral.
L1-L7 flashes when no cables are connected or a signal failure (> 0.5s).
Only selected LEDs indicate the LED operation during setup. Test your
changes during setup.
- Insert the jumper into one connector position
1 to 6, S, W to select LEDs L1 to L6 or S
(stick), W (wheel).
- Use the jumpers in the SET connector to set
the desired properties of the selected LED, S,
W.
SETTINGS
(without programming)
- To finish the setting, remove the jumper from connector 1 to 6, S, W
and then remove the jumpers from the SET connector.
Move the stick to
neutral
and wheel
straight
for 1s.
Control of hazard blinkers and
by steering wheel.
footlights
+L
L2B
+
Select LED L2
W S 6 5 4 3 2 1