User Manual
AUBION X.8
10/29
6.1.8 S/PDIF settings
For the S/PDIF-In, you can only select the source for the two input channels 7-8 with the
changeover switch: S/PDIF-In 7-8 or Line-In 7-8 (see section 6.1.6).
Otherwise, both the two S/PDIF input channels as well as the two S/PDIF output channels
(Out 3-4) are input/output at an unchanged level and are each available as ASIO channels
on your PC.
When you set the synchronization master source
Master
(see section 6.1.10), the sample
rates of the two ingoing S/PDIF channels are converted to the local master rate (sample rate
conversion).
6.1.9 Selecting the monitoring channel
For the stereo headphone output, one of the following ten signal sources can be selected for
monitoring: Out 1, Out 2, In 1 to In 8. These signal sources are output equally on two
headphone channels.
The monitoring channel is supplied from the channel that
was configured last – either by sliding the respective fader,
by clicking the In/Out switches below the fader, by using the
Mic/Line switchover or by changing the phantom power
supply setting.
The monitoring channel source signal for the two Line-Out
channels is located behind the digital attenuator and in front
of the analog setting for the full scale (see section 6.1.3 as well as the total block diagram in
section 0).
The monitoring channel source signal for the input channels is located behind the analog
input amplifiers.
You can also select the respective monitoring channel on the device itself.
Warning: The headphone level may be so high, that even after a short exposure a hearing
damage may occur. To avoid a hearing damage, do not expose your ears for a long period
with a high audio volume.
