10
Mac OS X Configuration
The following instructions are for Mac OS X only. Please note that DSE is only able to support
Mac OS X. Any earlier versions are not supported.
1. After restarting, you will need to set up the internet/networking, go to the System
Preferences and click Network.
2. When Network preferences opens, it should state that a new adapter has been detected,
you will need to select the new adapter from the drop down list under Show (your modem
should show as Ethernet Adaptor en1 or en2 depending on what else is installed in the
computer).
3. Change to the PPPoE tab and uncheck the box Connect using PPPoE.
4. Set the adapter to Using DHCP in the Configure field, then click Apply Now. An IP
address of 10.0.0.3 subnet mask of 255.0.0.0 and Router address of 10.0.0.2 should now
appear on the screen, make a note of the Router address here, you will need it in the next
steps to configure the modem.
5. Open your web browser and type in the Router address (see above, default is 10.0.0.2), it
will prompt you for a gateway login and password, (default login is admin and
default password is epicrouter.
6. From the router configuration screen, click WAN under Configuration then check that
Encapsulation is set to PPPoA VC-Mux, VPI is set to 0, VCI is set to 100, set Static IP,
subnet mask and Gateway are all set to 0.0.0.0 then enter your username and password
provided to you by your ISP into the fields provided, then click the Submit button at the
bottom of the page, then scroll down and click the Save Configuration link at the bottom of
the page, then click Submit on the next screen which appears.
7. Once you have completed the above steps, you should have a connection to the internet
via your XH1148 ADSL modem.
