Document: RY-BCC8FDL 2A0
Page: 3
OWNER'S MANUAL
RY-BCC8FDL IP camera license plate
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
good to frame a narrowest possible width around the
location where it will be located in the plate so that the
same appears as large as possible in the frame.
Once defined the field of view act on the FOCUS button to
focus perfectly framed area.
Recall that each lens has its own depth of field to which it
is possible to put in focus in a perfect way only a portion
of the space in front of the camera. Concentrate on the
most important area where you will find the plate of the
vehicle to adjust the focus optimally. Make sure you have
a large monitor as much as possible to be able to properly
evaluate the quality of detail.
It may be useful for a correct adjustment of the lens
position a car stops at the exact point where it carries out
the reading of the license plate. This adjustment should
be carried out in night vision, where conditions are worse.
ADJUSTING LIGHT LED
The camera incorporates an internal infrared LED
illuminator high power lighting that gives off invisible to
the human eye.
The illuminator turns itself on when it gets dark and the
camera switches alone in night vision mode. The
illuminator ignition allows the vision of absolute darkness
plate until its flow rate of about 30 m lighting.
Verify that the LEDs light up at night and visible in their
red light because the LED access is essential for night
number plate reading.
If the LEDs do not light up check that there are no
nearby light sources to the camera.
Normally there is no need to change the power of LED
lighting, but if the plate is read at close range may notice
the license plate too bleached. In this case it may be
necessary to reduce the power of the LEDs. To change
the power of the LEDs you must click on the UP and
DOWN buttons on the camera control. Clicking again on
these buttons you can visually control the power of the
LEDs is changed.
To prevent the restart the camera restores the brightness
of the LED factory can store the adjustment you've set
recalling the preset 99 or 201. Choose presets and then
press the button with the arrow.
SETTING THE CAMERA
The RY-BCC8-- camera is pre-programmed for the best
performance in the detection of plaques. And yet you can
make some adjustments to adapt perfectly to the
environment and the means to shoot. To make these
adjustments using the second application on the CD
called IPC.EXE. It is a program that requires no
installation and is made up of a few files. You can also
copy the folder to a flash drive and use it on any PC on
the network.
IT 'S THE ADJUSTMENT IN SHOOTING NIGHT.
The program shows in the top left-RY BCC8-- cameras
found on the net. We first need to select a camera, enter
the USER NAME and PASSWORD (admin / empty factory)
and click LOGIN. The message: LOGIN SUCCESS.
Now press the PLAY button to preview the video of the
camera.
This preview page can be used to view the camera's
reactions and possibly for lens adjustment.
The adjustment of the camera parameters can be found
in the lower left
MODEL
It represents the mode of operation of the camera and
adjusts from 1 to 6 depending on the speed of the
means. Adjustments 1 to 4 are used for moderate speed.
Adjustments 5:06 are used for high speeds and provide
images darker globally.
