Document:
RY-BCC8 1G4
Document:
RY-BCC8 1G4
Document:
RY-BCC8 1G4
Page:
3
Page:
3
OWNER'S MANUAL
RY-BCC8 IP camera license plate
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
E 'can modify parameters as desired and click INSTALL to transfer to the camera. The success
of the operation is confirmed by the message OK INSTALL.
It should be noted that in order to proceed with these adjustments it is necessary that there are
It should be noted that in order to proceed with these adjustments it is necessary that there are
no clients on the network . The adjustable parameters are as follows:
no clients on the network . The adjustable parameters are as follows:
MODE
- There are two options Mode 1 and Mode 2. Mode 1 is used when the night light is
MODE
- There are two options Mode 1 and Mode 2. Mode 1 is used when the night light is
expected as low or absent in the filming of road sections. MODE 2 is used when the night
brightness is expected always good such as filming at tollbooths. Of the camera factory is set to
MODE 1, which is normally recommended for most applications.
SPEED
- This parameter should be adjusted according to the maximum speed of the means.
SPEED
- This parameter should be adjusted according to the maximum speed of the means.
The available options are: 30 Km / h, 60km / h, 90km / h, 120km / h, 150 km / h.
BRIGHTNESS
- This parameter defines
BRIGHTNESS
- This parameter defines
there
Night image brightness to be obtained. If you select an image with general low light also it has
greater protection against the glare of the headlights. There are 4 levels Normal, Low, Medium,
High.
VIEWING THE CAMERA
The camera is based on ONVIF protocol and for this reason can be connected to any NVR.
To evaluate the video quality can also connect with the Internet Explorer browser by typing the
IP address of the camera.
However, this connection is not necessary because the web interface does not intervene in the
license plate reading capabilities.
Type the credentials of USER: admin PASSWORD: admin Take care that the first camera
access must install the ActiveX components in the browser. If not, head in the Explorer security
settings and custom settings enabled all options regarding the download and execution of
ActiveX is marked safe for you not marked as safe. It will see the image of the camera. Through
the IE browser you can also adjust some of the camera's performance parameters but you
should not change them to avoid compromising the ANPR functionality.
LIGHT LED
The camera incorporates an internal illuminator high power LED lighting that gives off visible to
the human eye.
The illuminator turns itself on when it gets dark and the camera switches alone in night vision
mode. The illuminator ignition allows the vision of absolute darkness plate until its flow rate of
about 30 m lighting ..
