Document:
RY-BCC8 1G4
Document:
RY-BCC8 1G4
Document:
RY-BCC8 1G4
Page:
2
Page:
2
OWNER'S MANUAL
RY-BCC8 IP camera license plate
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
In general, it is good to frame a narrowest possible width around the location where it will be
located in the plate so that the same appears as large as possible in the frame.
Once you defined the field of view act on the FOCUS ring to focus the perfectly framed area.
Recall that each lens has its own depth of field to which it is possible to put in focus in a perfect
way only a portion of the space in front of the camera. Concentrate on the most important area
where you will find the plate of the vehicle to adjust the focus optimally. The commissioning focus
adjustment is crucial for the success of the license plate reading. Make sure you have a large
monitor as much as possible to be able to properly evaluate the quality of detail.
It may be useful for a correct adjustment, position a car stops at the exact point where it carries
out the reading of the license plate.
The lens adjustment ring nuts can be rotated only after having unscrewed the pawl. Retighten
after adjustment in order to avoid unwanted changes.
NETWORKING
Connect the network port of a port of the network switch camera with a right network cable.
Check that the yellow LED on the connector starts to flash, which confirms that the network has
established dialogue.
IP ADDRESS ASSIGNMENT
The camera IP address Factory
192.168.0.199
The camera IP address Factory
192.168.0.199
The factory logon credentials:
USER: admin
PASSWORD: admin
To change the IP address of the base and make it consistent with that of your network using the
Windows program
SEARCHIPCAMERA
the CD. It is a program that does not require installation
Windows program
SEARCHIPCAMERA
the CD. It is a program that does not require installation
Windows program
SEARCHIPCAMERA
the CD. It is a program that does not require installation
and consists of two files only. You can also copy the folder to a flash drive and use it on any PC
on the network.
Run the program and click SEARCH. The program will search all RY-BCC8 cameras on the
network and list them in the table.
Select the camera click EDIT
Set the address you want, and the subnet mask and gateway of your network and click OK to
refresh. Remember that the first 3 IP Address numbers must be the same for all network
elements (cameras, PCs, routers etc.)
SETTING THE CAMERA
The RY-BCC8 camera is pre-programmed for the best performance in the detection of plaques.
And yet you can make some adjustments to adapt perfectly to the environment and the means
to shoot. To make these adjustments using the second application on the CD called
SPEED CONFIGURATION TOOL.
It is, also in this case of a program that does not require
SPEED CONFIGURATION TOOL.
It is, also in this case of a program that does not require
installation and consists of only 2 files. You can also copy the folder to a flash drive and use it
on any PC on the network.
Enter the IP address of the camera you want to configure and click ENTER
to execute
the
connection. The message: ENTER OK. Now press READ to read the current settings of the
camera.
