DSC PC5132-433, Руководство по установке, Страница: 8 / 28

4
This section describes how to enroll wireless devices (WLS904P-433, WLS906-433, WLS907-
433, WLS912-433, WLS914-433 and WLS925L-433), and wireless keys (WLS909-433 and
WLS919-433). For more information on these devices, read the instruction sheet included with
each device.
3.1 A Note about Electronic Serial Numbers
An electronic serial number (ESN) is printed on the back of each wireless device. ESNs
are used to enroll the wireless devices with the PC5132-433 receiver.
In order to reduce the occurrence of wireless devices with the same serial number, 6-digit
serial numbers are now printed on the back of each wireless device. The 6-digit serial
numbers include hexadecimal digits. For instructions on programming hexadecimal
numbers, see your system Installation Manual, Section 4: How to Program.
NOTE : 6-digit serial numbers are only supported on the following control panels:
PC5020, PC501X, PC1555 and PC580 v2.0 and higher.
The WLS904P-433, WLS906-433, WLS907-433, WLS912-433, WLS914-433 and
WLS925L-433 devices have both a 5-digit and a 6-digit serial number printed on
them. When connecting the PC5132-433 to a PC5010 v1.x panel, enter 5-digit serial
numbers only. When connecting the PC5132-433 to a PC5020 or PC5015 v2.x and
higher, PC5010, PC1555, or PC580 panel enter the 6-digit serial number.
3.2 Enrolling Wireless Devices
1. At a system keypad, enter [
✱
][8][Installer’s code] to go to the installer’s
programming section.
2. Enter programming section [804].
3. Enter the 2-digit number corresponding to the zone the device is to occupy
([01] to [32]).
NOTE : Hardwired and wireless devices cannot be assigned to the same zone. PC5108
zone expander modules occupy zones in 2 groups of 4 (e.g. zones 9-12 and zones 13-
16). None of the zones assigned to a PC5108 module may be used for wireless devices.
For more information on zone assignment, consult your system Installation Manual.
4. Enter the device’s ESN. Follow the instructions in section 3.1 above.
5. Record the serial number and the assigned zone number in the programming
worksheets in the back of this manual.
6. Continue with steps 3 - 5 until you have enrolled all wireless devices.
7. To exit press [#]. The device is now enrolled on the system.
NOTE : The devices will not work properly until you complete zone and partition pro-
gramming (see section 4).
3.3 Enroll & Program Wireless Keys
For wireless keys to work on the system, you need to enroll them and then program the
function buttons. Wireless keys are not assigned to zones and require no zone
programming. You can enroll up to 16 wireless keys on the system.
NOTE : Control units must have the ‘Arm/Disarm Bell Squawk’ feature enabled when
using wireless key devices. The bell squawk must be heard outside of the home.
S E C T I O N 3
Enrolling Wireless Devices