3
S E C T I O N 2
This section describes how to set up and wire the PC5132-433 module.
2.1 Unpack the PC5132-433
Check that the following parts are in your PC5132-433 package:
• PC5132-433 PCB
• Diversity antennae
• PC5132-433 plastic cabinet
• Hardware for mounting the cabinet
2.2 Choose a Mounting Location for the PC5132-433
NOTE
: Mount the PC5132-433 receiver and wireless devices after you have done
placement tests with the wireless devices (see sections 5.1 and 5.2).
Find a place that is:
• Dry
• Central to the proposed placement of all wireless devices
• As high as possible
• Far from sources of interference, including: electrical noise (computers,
televisions and electric motors in appliances and heating and air
conditioning units); large metal objects like heating ducts and plumbing
which may shield the antenna.
Make sure that electrical wires will not run over the antenna(s) of the module when
it is mounted.
When mounting the PC5132-433 in a basement, place the module as high and as
close to the underside of the first floor as possible. The range of the module will be
reduced if the unit is mounted below ground level.
2.3 Installing the Antennas
The two antennas must be screwed into the terminals marked ANT1 and ANT2, not GND1
and GND2. Also they must be installed as indicated in the following two diagrams:
Do not install the antennas as indicated in the following diagrams:
If the antennas are installed incorrectly the PC5132-433 may not
reliably receive signals from the transmitters.
2.4 Connect the PC5132-433 Receiver
CAUTION: Remove all power from the system
while connecting modules to the Keybus.
Connect the PC5132-433 to the four-wire Keybus
of the control panel according to the following
diagram.
After you have completed the wiring, reconnect
the power to the security system.
Now that you have wired the PC5132-433, you should enroll and program the
wireless devices. See section 3 for instructions.
PC5132-433 Set Up & Wiring