I n t r o d u c t i o n
4
1.2 How to Use This Manual
To install and set up the PC4164 and wireless devices, follow these steps:
1. Enroll and temporarily mount the PC4164 module (see
Section 2
)
2. Enroll and program wireless devices using zones, wireless keys and
handheld keypads (see
Section 3
)
3. Complete zone and other programming on the system (see
Sections 4 and
5)
4. Test the placement of all the wireless devices
(see Section 6)
5. Permanently mount the PC4164 receiver and wireless devices
(see Section
6)
To replace or delete wireless devices already enrolled, see
Section 4.
For additional information on wireless motion detectors and wireless keys,
see
Sections 7 and 8.
For help with troubleshooting, see
Section 9.
Record the zone or slot and serial numbers of all wireless devices, and other
programming in the
Programming Worksheets
section at the end of the man-
ual.
PC4010/4020 Programming
All programming sections in this manual are referred to by reference num-
ber. A detailed description of PC4010/PC4020 programming is in the
PC4010/PC4020
Installation Manual, “How to Program.”
To program using reference numbers, enter Installer’s programming
([*][8][Installer’s Code]). Press and hold the [A]uxiliary key until the keypad
displays the following message:
“Enter Ref # then *.”
Enter the reference number found in the Programming Worksheets for the
section you wish to program, then press the [*] key. The display will imme-
diately go to the programming item you have selected.