U s i n g Y o u r N T 9 01 0 S ys te m
7
Remote Telephone Access
NOTE:
Pause for one second between key presses when entering access
codes or commands on a remote Phone
1. From any touch-tone telephone, dial number of the line on which your NT9010
has been installed.
2. After one ring, hang up. Wait 10 seconds then call again. On the second call,
the system will answer after one or two rings and announce:
“Hello.”
3. Enter your 3-digit Telephone Access Code within 10 seconds. If you wait longer
than 10 seconds, the system will automatically hang up.
4. The system will then prompt:
“Enter your access code.”
Enter your [access code] within 20 seconds. If you wait longer than 20 seconds,
the system will hang up. The system will also hang up if 3 incorrect access
codes are entered.
5. Once you have entered an access code, the system will announce one or more
messages to advise you of its status. Follow the voice prompts to use the sys-
tem functions.
NOTE:
There is only one “Telephone Access Code”. It is programmed by
your installer. It is not the same as your 4- or 6-digit system access code.
More than one system access code can be programmed for use by different
users of your system (see Programming Access Codes on page 21).
Receiving
Incoming
Calls
If you are accessing the NT9010 system over a local telephone at the same time as
someone calls you, the system will announce:
“Attention, you have an incoming call. To receive the call, press pound now.”
To answer the incoming call, press
. If you do not press
, you can continue
to use the system.
Recording and
Playing Voice
Memos on the
NT9010
You can record a voice memo on the NT9010 controller to be listened to at a later
time. To record a voice memo:
1. Press the Record function button. The NT9010 says “Record memo now, To
complete press [#]“. The maximum memo length is 20 seconds.
2. Speak into the microphone (located in the top left corner of the unit). When
you have finished recording, press
. The green Ready light flashes to indicate
a new memo has been recorded.
To listen to a voice memo:
1. Press the Playback function button. Once the memo has been played, the green
Ready light stops flashing, but the memo remains in memory until a new one is
recorded, or until the NT9010 loses all power.
2. If the memo is not for you, you can press
to stop the playback. If you press
before the playback finishes, the Ready light will continue to flash.
#
#
#
#
#