DSC COMMUNIQUE VPM4580, Руководство по установке

Страница: 15 / 56

9
[020] Local and Remote Telephone
Access Code
This 3-digit code allows access to the system through
a telephone on the premises, or from a remote phone.
The default Telephone Access code is [***]. Enter a 3-
digit code using the numbers 0 through 9, and/or the
signs [#] and [*].
Important Note: Avoid programming a telephone
access code that coincides with 3-digit local telephone
numbers and services. In most areas, 0xx, 411, 911 and
611 should not be used as a telephone access code. Also,
in some areas, telephone services may be available by
dialling [*] and 2 digits. Ensure that the telephone
access code is not the same as any of the [*] functions
available from the service provider.
Telephone Access Programming
[021] Telephone Access Options
Option
01 ON Remote Access Enabled. The user will
be able to access the system from
remote touch-tone telephones. To
gain access to the system, the user
must call the system and hang up
after one or two rings. The user then
calls the system again. When the
system answers the call, enter the
Telephone Access Code to access the
system.
OFF Remote Access Disabled. The system
will not allow access from off-
premises telephones.
NOTE : To enable VPM4580 remote access, you must
also turn on the DLS Enabled toggle option in the
DLS Toggles section (reference number [000300])
of the PC4010/4020 control panel.
02 ON Access Code Always Required for
Local Access. When the user picks up
a premises telephone and enters the
(3-digit) Telephone Access code, the
system will require that a valid (4- or
6-digit) Access code be entered.
OFF No Access Code Required for
Partition Access. When the user picks
up a premises telephone and enters
the (3-digit) Telephone Access code,
the VPM4580 provides immediate
access to the system.
S e c t i o n 6
firealarmresources.com