DS18 JL- HARNESS, Руководство пользователя

Страница: 7 / 8

Soundbar Side
A - Sound Bar Connector: this goes outside the soundbar and allows us to
connect and disconnect it for any service, speaker replacement or
facilitate the installation.
B - RGB LED light wire: connect this to each RGB LED lightings such
as speakers, rings, grills, tweeters, and DS18 Badge used for the
Soundbar.
Black: +12V, Red: Red color (-), Green: Green color (-), Blue:
Blue color (-).
C - Speaker Wires: connect these wires to each speaker in the soundbar
like this:
Speaker 1 and Tweeter 1 connected in parallel to the wire: White: (+),
White/Black: (-)
Speaker 2 and Tweeter 2 connected in parallel to the wire: Green: (+),
Green/Black: (-)
Speaker 3 and Tweeter 3 connected in parallel to the wire: Gray: (+),
Gray/Black: (-)
Speaker 4 and Tweeter 4 connected in parallel to the wire: Violet: (+),
Violet/Black: (-)
*Always use the bass blocker (filter) on each tweeter to avoid burning it.
6
FINAL STEP
1. Run the positive power wire to the front battery under the hood, you can
use the existent drain caps on the floor in the seat area to pass through
the wire and route it to the battery
2. Secure the wire use zip-ties to the chassis or factory harness nearby and
keep it far away from the header / exhaust.
3. Connect it on the Positive (+) terminal of the battery and secure the fuse
holder in an accessible area using screws or zip-ties.
4. Once all is connected, put back the seat and make sure all connectors
are plugged-in so you can re-connect the negative post (Ground) of
the battery.
5. Turn on the Radio and check sound making sure that all speakers are
playing, then adjust the amplifier’s gain and crossover point to your
preference.
6. Enjoy your new DS18 JL-HARNESS.