DS18 JL- HARNESS, Руководство пользователя

Страница: 5 / 8

1 - "Front” amplifier audio signal connector: connect this using the supplied
RCA connector and connect this to the amplifier CH1 and Ch2 RCA input.
(Using front speaker upgrade)
“Rear” Amplifier Audio Signal Connector: connect this using the supplied
RCA connector and connect this using “Y” RCA splinter to the amplifier CH3
to CH6 RCA input. (Using a 6CH amplifier with front speaker upgrade)
2 - Speaker harness: Connect the Front Speaker Harness to the “Front”
output amplifier channels: White: CH1(+), White/Black: CH1(-), Gray:
CH2(+), Gray/Black: CH2(-) and Connect the Soundbar speaker harness to
the channels 3 to 6 of the amplifier: White: CH3(+), White/Black: CH3(-),
Gray: CH4(+), Gray/Black: CH4(-), Green: CH5(+), Green/Black: CH5(-),
Violet: CH6(+), Violet/Black: CH6(-).
3 - Amplifier Power wires, Red: Positive from the battery, Black: Negative
Ground, Blue: Remote turn-on.
4 - Smart Line Output Conversion Module: this is a Plug and Play connector
using this module (V4HL.V2). This module converts the speaker signal from
the factory radio to a low-level audio signal for the amplifier, this also has a
speaker emulator that enables the signal output of the factory amplifier and
provides the Remote turn-on for the amplifier and LED Module.
Amplifier Side Installation
4
**ATTENTION** Disconnect the negative post (Ground) of the battery before you
start the installation. This helps avoid airbags coding and malfunctions, codes
module malfunction or any electrical issues
FACTORY RADIO
HARNESS
DS18
T-HARNESS
RADIO
FACTORY
RADIO
DS18 HARNESS
(RADIO SIDE)
SPEAKER /
SIGNAL CONNECTOR
FROM RADIO SIDE
WHITE
WHITE / BLACK
GRAY
GRAY / BLACK
WHITE
WHITE / BLACK
GRAY
GRAY / BLACK
HARNESS SIDE
NOTE: If you use 4 or 5 Channels
amplifier without upgrading the
front speaker you will need to
bypass the “Front” signal. Use only
the “Rear” signal to JL-SBAR or
subwoofer channels.
Cut the wires: White CH1(+),
White /Black CH1(-), Gray CH2(+)
and Gray/Black CH2(-) from each
Harness side speaker/signal
connector and connect each same
color together using crimp wire
connectors: