DryBell Vibe Machine V-2, Руководство по настройкам

Страница: 13 / 18

DryBell Guitar Effects www.drybell.com Vibe Machine V-2, Options User’s manual, rev.1.4. 09/2018
BACK TO CONTENTS
DryBell
Doc. No. DM0958/ Page 13
must be powered with a power supply that is able to provide sufficient current (mA) for proper function (minimum 165mA
and minimum 8.91V). If the voltage is lower than 8.91V the pedal will not function properly. It’s not necessary, but it is
recommended to power the Vibe Machine using a galvanically isolated power supply.
Because of all of the above, the V-2 has a built in function that can check the voltage level (daisy chain), and measure
the intensity of unwanted pulsating voltage. The power supply voltage checking process is initialized automatically during
every power up. To perform this check set the pedal as follows:

Main footswitch in ON position

Set the Chorus/Vibrato switch to “CHORUS”

Plug any MONO guitar cable into the PEDAL+ jack

Set intensity to maximum
After setting the pedal as described above, plug the power in (or reconnect the power supply). For 2 seconds LED
won’t come on. Then it will blink ORANGE for 2 seconds in speed rhythm. After that, and if the voltage is ok, it will light
GREEN continuously for 4 seconds. Only if you get a continuous GREEN light for 4 seconds does it mean that the voltage is
correct. All other colour/blinking variations suggest that the voltage is not correct.
The power supply voltage can only be checked using the settings described above and only during power up, there is
no other way to perform this task.
Table 3. Shows the powering up sequence when power voltage is OK
Powering
up
The period in which the system
measure and analyze the power
supply voltage.
If the power line is OK regarding voltage
range and noise, the system LED will light
continuously.
Start normal
operation.
2 SECOND 2 SECOND 4 SECOND ∞
NO LIGHT ORANGE BLINKING CONTINUOUS GREEN LIGHT
GREEN
BLINKING
Table 4. Shows the powering up sequence when power voltage isn’t OK
Powering
up
The period in which the system
measure and analyze the power
supply voltage.
If the power line is not OK regarding voltage range and
noise, the system LED will start pulsate green.
2 SECOND 2 SECOND ∞
NO LIGHT ORANGE BLINKING GREEN BLINKING
10 A FEW THINGS REGARDING THE V-2 SYSTEM FIRMWARE

The main LED above the footswitch is used just to signal whether the pedal is engaged or in bypass. That LED is
not controlled in any way with pedal’s firmware. When it is on, the pedal is engaged, when it is off, the pedal is in
bypass.

When powering up, the system LED won’t go on for first 2 seconds.

When exiting the Cancel mode, a very short while is needed before standard vibe effect can occur. During that
time the system LED will light up orange. When it goes to green it means that the optical system with its
incandescent lamp has reached its nominal dynamic working state.

When you are choosing PEDAL+ modes set the knob on marks E1, E2…S6.