23220 W. 84
th
St., Shawnee, KS 66227
Phone: (888) 633-1973
Brian Jennett- Tech-Line/Service Manager ext 8575
http://www.DryLam.com
27STA Instruction manual.docx Page 22 of 24
block. Be sure the thumb screws are all on top, and both slitter edges are facing the front of
the laminator.
(See Figure 2)
Adjust slitters to cut where you wish and tighten the thumb
screws. Remove protective coating from slitter blades.
FIGURE 2
4) Drop slitter into the mounting brackets and press slitters through laminating film. Once
slitter bar is in place, slide each locking block out until it contacts the mounting brackets,
tighten the thumb screws.
NOTE:
When pressing the slitters through the laminating film, try cutting a slot in the film with
a utility knife first.
