23220 W. 84
th
St., Shawnee, KS 66227
Phone: (888) 633-1973
Brian Jennett- Tech-Line/Service Manager ext 8575
http://www.DryLam.com
27STA Instruction manual.docx Page 11 of 24
counter can be reset to zero by pressing the "Count Reset" button once the display is showing
the usage counter.
ADDITIONAL FEATURES
Key switch
The key switch (located just below the control panel) locks out the motor, allowing the
machine to remain heated; yet, preventing unauthorized usage when in the locked position.
Hand Held Cutter
If additional cutters or cutter blades are
needed, they may be obtained from
DryLam.
The hand held cutter blade can be
replaced by removing the small screw
on the back of the cutter, then
removing the cutter back.
Caution: The
cutter blade is extremely sharp. Please
handle carefully and dispose of
properly.
Remove and discard the old
blade. Re-install cutter back and screw.
Caution: Do not over tighten screw.
