6
Fig. 2-2 Unit Dimensions
High voltage conn. 1-23/64” dia. knockout
Low vlotage entrance 7/8” Dia.
High voltage conn. 1-23/64” Dia.
Electrical service access
compapartment panel
Condensate drain
connection 3/4” NPTI
(Trap required)
Drain pan service access
compartment panel
Recommended unit
disconnect location
6-1/2”
Front
Left
Unit size
036
048, 060
Dimensions
A
28-3/32”
33-3/64”
* The above figure for reference purpose only.
A
Direction
Distance (in.)
Direction
Distance (in.)
Top
Front
Rear
Right
Left
Bottom
30
60
18
12
24
0
Duct clearance: 1 inch clearance for all sides of air supply duct.
1. Units must be installed outdoors. Over hanging structure or shrubs should not obscure condenser air discharge outlet.
2. The minimum clearance without economizer/fresh air damper. For distance with Economizer/fresh air damper, please refer
to the relevant Install requiremnt.
Table 2-1: Unit Clearance
NOTE
For units applied with a roof curb, the minimum clearance may be reduced from 1 inch to 1/2 inch between
combustible roof curb material and this supply air duct.
1
3
2
Hi./Lo. pressure
detected valve
1/4’’ SAE
