Druck ADTS 405 R/F, Инструкция по эксплуатации

Страница: 8 / 12

Copyright 1998 Baker Hughes Company.
6 | ADTS 405 Altimeter Encoder Option User Manual–English
Press SAVE, then repeatedly press QUIT until the display shows the following:
Note: With an incorrect bit combination such as all zeros, the display shows “ENCODER
ERROR” in the place of the decoded value.
All normal ADTS
405 functions remain active when using the encoder option with all the normal
parameters available. The display shows all parameters except altitude as a single parameter in
the upper half of the display.
To set power-up defaults for this option, enter the CONFIG menu, select options and then
encoder as follows:
Press the SAVE key, to store the selection, then repeatedly press QUIT until the display shows
the normal encoder option data.
3.2 Errors
The display shows “ENCODER ERROR” in the place of a decoded altitude value when the bit
pattern does not decode to an equivalent altitude.
3.2.1 Bit Pattern All Ones
Possible causes:
1. Altimeter encoder option not fitted.
1 Controlled or measured parameter. 2 Aim (set-point or target) in control mode,
or “Leak Measure” when the pressure
controller is off.
3 Measured value. 4 “<” Pointer for parameter, i.e. aim that
changes on data entry.
5 Units of measurement. 6 Altitude encoder bit code.
7 Special messages, e.g. warm-up
period.
8 Altitude encoder decoded value.
Alt 5000 ft
Aim 5000<
D2 to C4>00001010010
CODE 5000 WARMUP
1
3
5
7
8
4
2
6
[SETUP + F1 (CONFIG)]
[MORE]
[DISPLAY OPTIONS]
[DISPLAY TYPE]
use [NEXT] or [PREV]
to select
[ENCODER]
Alt 5000 ft
Aim 5000<
D2 to C4>11111111111
CODE ENCODER ERROR