Dru SAXO, Инструкция по установке и эксплуатации

Страница: 30 / 72

Positioning the logs
Position the logs as follows:
• Lay the large log against the back wall.
• Fill the burner with vermiculite.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.g l i s h
• Sprinkle the chips on top of the vermiculite and on the
tray surrounding the burner tray.
• Now lay the rest of the logs in place as illustrated in fig. 9.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.
Fitting the glass panel
Saxo
Once the logs are in position the glass pane can be hung
back in the hinges on the left or right, depending on
whether you have a side window on the left or the right.
Fasten the glass pane with the 2 socket-head screws. NB:
Damaged or broken or damaged glass should be replaced
immediately.
Saxo SL
Once the logs have been positioned, the glass panes can be
replaced.
• Fit the side panes into the retaining strip.
• Fix the strip with the screws.
• Fit the front pane into the retaining strips.
• Make sure that the panes join neatly in the corner.
• Fix the retaining strip.
For safety reasons a guard should be placed in
front of the fire at all times.
Mounting the front panel
The coloured frame is packed separately to the basic set.
Hang the hooks of the front panel onto the combustion
chamber and press it onto the magnets.
Remote control
Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life expectancy
of approximately one year, feed the electrical supply.The
remote control will only work if the pilot light is lit.
Connecting the Receiver
The remote control system comprises a receiver and a
remote control, packed together in one box.The receiver
must be connected to
the appliance fitting the
batteries.
This is done as follows:
• Take the receiver out of
the box.
• Slide the brown plug of
the cable onto the
receiver circuit board
(fig. 10).
• Connect the white plug
to the connector on the
gas control valve.The
different sized plugs
INSTRUCTIONS FOR INSTALLATION
26
fig. 9
Vermiculite
Chips
fig. 23
A
B
C
reset