Dru Pronto G20, Инструкция по установке, Страница: 5 / 24

5
English
P R O N T O
-
I N S T R U C T I O N F O R I N S TA L L AT I O N
After removing the packaging, you should have the following components:
-
Socket spanner; you will fi nd it in the space between the assembly frame and the combustion chamber;
- Box with parts; you will fi nd it in the combustion chamber.
Remove the box containing parts from the combustion chamber.
In appendix 1 / table 4 you can see which parts you should have after removing the packaging.
Contact DRU Service if you do not have all the parts after you fi nished removing the packaging.
Dispose packaging in accordance with local regulations.
6. Installation
Read this manual carefully to ensure a proper and safe operation of the appliance.
!Caution Install the appliance in the order described in this chapter.
6.1 Regulations
Observe the applicable (installation) regulations.
Observe the regulations/instructions in this manual.
6.2 Type of gas
The type plate indicates for which type of gas, gas pressure and for which country this appliance is intended. The type
plate is located at the inside of the small ornamental cover.
Remove the small cover at the underside of the front pane by unscrewing the bolt at the left and right side. After
removing the cover you can see the type plate (see
Fig. 2 ).
6.3 Gas connection
Place a gas tap in the gas connection, under to the appliance.
Caution Avoid dirt in the gas pipe and in the connections.
The following requirements apply to the gas connection:
use a gas pipe with the correct dimensions, so that no pressure loss can occur:
the gas tap should have the CE marking;
you should always be able to reach the gas tap.
6.4 Placement of the appliance
Place the appliance as follows:
Caution - Suspend the appliance from a wall of incombustible and heat resistant material;
- Take into account the minimum required free space of 500 mm at both sides of the appliance, as well as above the
appliance for the benefi t of the appliance’s heat discharge;
- Suspend the appliance at least 300 mm above the fl oor;
- Make sure that combustible objects and/or materials have a distance from the appliance of at least 500 mm;
- Do not make any changes to the appliance.
Fig. 2 Fig. 1
38c-1411
U K
95901302UK Install_G20.indd 5 95901302UK Install_G20.indd 5 2-2-10 14:28 2-2-10 14:28