Drolet R.C. WOODSTOVE, Инструкция по эксплуатации, Страница: 7 / 16

You may decrease these clearances by installing heat radiation shields between the walls or the
ceiling and the stove. These heat radiation shields must be installed permanently, and can
include sheet metal, a rigid non-combustible sheet or a masonry wall.
Following the installation of such a heat radiation shield, the clearances mentioned on
the stove certification plate may be reduced as stated in the following table.
Reductions in Clearance to a Combustible
Walls (or Ceiling) and the Heating Device
TYPE OF PROTECTION
SIDES AND
REAR\BACK
TOP
Minimal requirements:
0,013" (0,33 mm) sheet metal with 1" (25
mm) fire-proof braces
67%**
50%
Ceramic tile or an equivalent fire-proof
material resting on fire-proof brackets
spaced 1" (25 mm) apart by fire-proof
braces
50%
33%
Ceramic tile or an equivalent fire-proof
material built on a fire-proof base resting
on sheet metal of at least 0,013" (0,33
mm) thick spaced 1" (25 mm) by fire-
proof braces.
67%
50%
Solid bricks, spaced 1" (25 mm) from the
rear wall using fire-proof braces.
50%
N\A
Solid bricks, resting on sheet metal 0,013"
(0,33 mm) thick spaced 1" (25 mm) from
the rear wall using fire-proof braces.
67%
N\A
**Example: 900 mm x (100% - 67%) = 300 mm
This reduction in clearance, when in compliance, is accepted by insurance companies.
6