Operation
Common Operation
1. To power the unit On/Off
When the unit is powered
Off
, it may be switched
On
by pressing the
POWER
button. When the unit is
switched
On
, press and hold the
POWER
button to switch it off.
2. To select a function mode
Press
MODE
button repeatedly on on the front panel to select the corresponding mode.
(FM/AM, AV1, AV2, BLUETOOTH, HDMI)
3. To adjust the volume level
During playback, press
or
VOLUME-
button on the front panel to increase or decrease the
volume.
4. To mute or resume the sound
During playback, short press
POWER
button on the front panel to mute sound. Repeat this to disable
mute function.
5. To check speaker output status and select speaker output
Short-press
ZONE 1
or
ZONE 2
button on the front panel to check the speaker output status.
Press and hold
ZONE 1
or
ZONE 2
button on the front panel to turn ON/OFF the corresponding speaker
output, “
Z 1 ON/OFF
” or “
Z 2 ON/OFF
” will be displayed on the LCD.
6. To set the sound mode and menu
Press and hold
SEL
button to turn on BASS, then press
SEL
button repeatedly to select or circulate
through TRE (treble), EQ OFF (FLAT/AMERICA3/AUSTRALIA/EUROPE), press /- to change the
settings. Press
SEL
button to confirm your selection.
- 1) VOL LAST / VOL DEFA
VOL LAST
: The last volume level setting will be saved automatically after the unit is swithced off, and
restored after powered on.
VOL DEFA
: Press SEL button on the front control panel, the AVOL mark will be displayed on LCD. Use
/- to set the volume level as a constant value.
- 2) VOL LAST / VOL DEFA
In Radio mode, with the DX/LOCAL selection you can change the attenuator settings at the input stage
of the radio. This selection helps to avoid overloading the radio when strong (local) stations are received.
Select DX (DISTANT) mode to receive far/weak radio stations (highest sensitivity settings are enabled)
and select LOCAL for very strong stations (which are located nearby).
-
NOTE
: This button is only for FM reception. In AM mode, LOC is in valid.
7. To display and adjust the time
Press and hold MODE button to display time.
Press and hold
MODE
button for ~ 2 seconds until the time displays then release and hold MODE button
again until the hour begins to flash. Use
/-
button to adjust the hour. While hours is flashing,
hold MODE button until minutes begin to flash then Use
/-
button to adjust the hour.
6
