15
• Direction. Press the power button, the light of for-
ward button illuminates to indicate the direction of
going forward. Press the backward button and its
light will illuminate to indicate the PS-HA will go
backward.
• Lift-up strap. The PS-HA comes with a lift-up strap
to allow the wheelchair to move when there is no
power. Lift up the PS-HA with the red strap and
hook the second loop around the push handle.
Please note that failure to lift up the PS-HA when
reversing may cause the pack to flip over.
• Maximum Speed. Always set a maximum
speed which you are comfortable walking with.
• Pushing the Wheelchair When Not In Use. We re-
commend that the powerpack is restrained with the
lift-up strap when not in use.
Please note there is a 2 - second delay when star-
ting up the PS-HA before the wheel will move. Wait 2
seconds before squeezing the trigger.
• Trigger – Squeeze the trigger to propel the PS-
HA. The more the trigger is squeezed, the faster
the PS-HA will travel. Release the trigger to stop
the PS-HA.
• Controller (Figure 2) – Press the Speed button to
increase (3) or reduce (2) the speed of the PS-HA.
Press the direction button to move forward (5) or
reverse (6) the PS-HA.
• Inner Knob – This is used to determine the angle of
the handle set.
1. Switch the PS-HA off at the Power Button.
2. Disconnect / unclip the powerpack connector from
underneath the handset.
3. Remove the lift-up strap from the push handle.
4. Lift the battery pack out of the battery tray by using
the handle of the battery and then by pressing the
PUSH button on the powerpack.
5. Remove the powerpack by pulling the Velcro strap
whilst pulling the powerpack from the rear of the
brackets (see the photo below).
6. Place all items in the carry holdall supplied.
Notes:
• The battery supplied with the PS-HA is classified as
safe for air travel by compliance with IATA special
provision A67.
• The battery pack and power pack have fabric hand-
les to make them easier to carry.
Figure 1: 1. Controller, 2. Inner Knob, 3. Trigger.
Figure 2: 1. Power Button, 2. & 3. Speed Adjust Buttons,
4. Battery Indicator, 5. Foward Button, 6. Reverse Button
Follow the procedure below step by step:
1. Turn the power switch to (OFF)
2. Lift out the battery pack using the handle on the
pack.
3. Plug the charger’s power cord into the mains.
4. Plug the charger’s round plug into the charging
socket of the battery pack
5. Switch on the plug socket.
6. The charger’s LED will illuminate orange to indicate
the batteries are charging. The charging duration
is about 8 hours. To ensure optimum performance
a 12-hour charge is recommended.
7. The orange LED will turn green when charging is
complete.
8. Turn off the charger, disconnect the power cord
and the round plug from the battery pack.
6
5
4
3
1
2
2
2
1
2
1
Operating the PS-HA
Handle Set Operation
Disassembly and Transportation
Battery Charging and Care
