installation
1. Remove bolts (A) on rear U-Bar.
2. Remove all mounting hardware (C) from
sliding bracket.
3. Insert mounting tubes (B) into opening on the
bottom of rear U-Bar (E), align U-Bar and
mounting tube holes, insert bolts (A) and tighten.
4. Remove and discard bolts (D). Replace with
mounting hardware (C). When assembled, the
hardware components should be positioned in
the following order: Starting from the inside of
the walker – bolt, washer, sliding bracket, washer,
nut, black plastic washer, U-Bar, black plastic
washer, outside frame connecting tube, black
washer and end nut (figure 3).
5. Tighten nuts and allow for slight play for the
sliding bracket.
operation
Flip up seat when standing and walking and fold
down seat for sitting and resting. Seat should be in
the up position when folding walker.
B
C
D
A
D
A
figure 1
figure 2
figure 3
figure 4
E