installation
1. Remove and discard bolts (A) on rear U-Bar.
2. Remove all mounting hardware (C) from
sliding bracket.
3. Insert mounting tubes (B) into opening on the
bottom of rear U-Bar (D) and align U-Bar and
mounting tube holes.
4. Install mounting hardware (C) at position
where bolts (A) were removed. When assembled,
the hardware components should be positioned
in the following order: Starting from the inside
of the walker – bolt, washer, sliding bracket,
washer, nut, black plastic washer, U-Bar, black
plastic washer, outside frame connecting tube,
black washer and end nut (figure 3).
5. Tighten nuts and allow for slight play for the
sliding bracket.
operation
Flip up seat when standing and walking and fold
down seat for sitting and resting. Seat should be in
the up position when folding walker.
B
C
figure 1
figure 2
figure 3
figure 4
A
A
D
