Hand rail
8
Removing the hand grips:
the hand grips are factory fitted and are a tight fit they will
need to be cut off using a sharp knife before the forearm platform can be fitted.
Carefully using a sharp knife make a cut along the hand grip, peel back the grip and
remove from the hand rail. The hand grips cannot be reused and should be discarded.
Step 1
Step 2
Fitting the Forearm Platform
To fit the armrest supports:
remove the nut, washer, spacer, bolt and middle spacer
from the hand rail (
a
). Slide on the armrest support, there are four holes for adjustment (
b
).
Line up one of the holes in the armrest support, push the bolt through the armrest
support, slide the middle spacer and the upright onto the bolt and secure with the
spacer, washer and nut (
c
). Repeat for the other side making sure that you use the same
hole in the armrest support.
b:
c:
a:
Hand
rail
Upright
