18
Instructions for use FREETEC
Drive Medical GmbH & Co. KG | As per: 26.05.2020 | Errors and alterations excepted
EN
Seat depth adjustment
Upon delivery, the seat depth of all models is set at 43
cm. This seat depth can be adjusted in a total of four in-
crements up to 50 cm. Before adjusting the seat depth,
open both Velcro fasteners on the seat cushion (photo
13) and fold the front part of the cushion forwards (photo
14).
13
14
To adjust the seat depth, remove both screws on the up-
per longitudinal tube on both sides (photo 15) as well as
the four screws below on the wheel mount fork, left and
right (photo 16).
15
16
Now you can pull the frame forward to the next hole (a
total of three times) and reinsert the screws.
Ensure that all screws are reinserted and tightened!
Fold the front seat cushion back again and refasten the
Velcro fasteners.
Adjusting the backrest and cushion
The degree of firmness of
the backrest can be indi-
vidually and continuously
adjusted using the 5 Vel-
cro straps (loosen or tigh-
ten) (photo 17).
To attach the back cushion,
place it as shown (pho-
to 18) on the wheelchair
and fold it over in succes-
sive parts.
Place part 1 on the inside
of the backrest, part 2 on
the back side, and smooth
part 3 from behind under
the seat surface.
The cushion is secured automatically by the integrated
Velcro straps (photo 19+20).
19
20
Adjusting the height of the backrest
The height of the backrest
can be adjusted in incre-
ments.
Note: When the backrest
is adjusted, the height of
the push handles is also
automatically adjusted.
To adjust the backrest,
remove the left and right
nuts under the guide tube
of the backrest (photo 21).
