Drinkwell FCB-REKA, Руководство по эксплуатации

Страница: 10 / 28

www.petsafe.net 11 10 www.petsafe.net
EN
KO
5. Once the Pump is disassembled you can clean the parts with warm water and
soap. Use a cotton swab or the “motor brush” from the Drinkwell
*
Cleaning Kit to
get into the Pump’s motor cavity and remove any build-up (
Fig. 11
). For added
disinfecting and hard water removal, clean the Pump’s motor with a diluted
vinegar solution (20% White Vinegar and 80% Water). Be sure to rinse
thoroughly with fresh water.
6. Once the parts are clean you can reassemble
the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate with the Flow
Control Knob attached to it.
Pet Fountain Reassembly
1. Replace the Pump by aligning the unit into its fitted space
inside the Bowl (
Fig. 12
). The suction cups on the Pump
should be facing down and the Flow Control Knob facing
into the Bowl. Gently push down to engage suction cups.
2. Thread the In-Line Plug of the electrical power cord
through the hole located next to Pump and push the rubber
gasket firmly into the hole. To insure the Pet Fountain Bowl
is stable, run the electrical power cord along the “cord
channel” and through the notch in the base of the Pet
Fountain (
Fig. 13
).
3. Attach the Housing by sliding the cutout in the wall of the
Housing down over the Flow Control Knob. The Housing
will click into place when the side tabs are inserted in the
Bowl (
Fig. 14
).
4. Replace the Charcoal Filter, with the black side facing the
front of the Pet Fountain towards the spout.
5. Fill the Bowl with water and replace the Housing Lid.
6. Place Pet Fountain in desired location. Do not pick up
a full Pet Fountain by the Housing. Only pick up the Pet
Fountain by placing both hands underneath the base of
the Pet Fountain and grip the sidewalls for a sturdy hold.
Important:
To protect your floor always use a protective
mat such as a towel or water-resistant placemat. This will
help protect your floor from any splashing or spills caused
by your pet.
7. Before you plug in the Pet Fountain make sure the electrical power cord, the
adaptor and your hands are dry. Connect the In-Line Plug and makes sure no
silver is showing then plug the adaptor into a standard electrical wall outlet.
Fig. 11
Fig. 12
Fig. 13
Fig. 14