www.petfountain.com
DRINKWELL
FOUNTAIN
BIG-DOG
®
3
FLOW CONTROL KNOB
Fig. 5
5. Make certain the cord and plug are dry, then plug into a polarized outlet (one
slot is larger than the other). The plug will only fit into a polarized outlet. Do
not attempt to force the plug into an old, unsafe outlet.
Use a UL approved
adapter if necessary.
The notches at the back of the fountain are a pass-through for the cord.
They are not for holding the cord snugly, which might damage the cord.
The cord should be passed through vertically. Do not turn the cord
horizontally and force into a notch as this may damage the cord and
create a hazard.
6. Fill the reservoir with water.
7. Check the lid to make sure the black O-ring is in place, then screw the lid onto
the container.
8. Hold the container over the reservoir base of the fountain. Quickly turn the
reservoir upside down and place the lid’s spout into the reservoir base, (Fig.
4).
9.
Set the desired flow rate with the flow control knob, which is next to the ramp
in the bowl (Fig. 5).
10. Add water to the reservoir when it appears low or slowly pour water directly
into the bowl. For quietest operation, fill bowl to the fill level. A gentle hum
during normal operation is to be expected. During regular use, do not allow the
water level to fall below the inlet grate on the bottom of the flow control knob,
or the motor may run dry.
Fig. 4
