Page 7
For technical questions, please call 1-888-866-5797.
Item 61311
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Specifications
Electrical Rating
120VAC / 60Hz / 1A
No Load Speed
12,000 OPM
Sandpaper Pad
4″ W x 4-1/2″ L
Dust Chute
1-1/4″ OD
Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the Switch is in the off-position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
note:
For additional information regarding the parts listed in the
following pages, refer to
Parts List and Diagram
on page 11.
assembly
Dust collection Setup
1. Turn the Dust Chute so that the tab on top of the
rectangular end faces up. Snap it in place into
the rectangular shaft at the back of the Sander.
2.
Connect a 1-1/2″ dust collection hose from
the Dust Chute to your dust collection
system (hose and system not included).
Use the Dust Connector (if needed).
3. The Dust Chute will only work if the sandpaper
has holes that line up with the 6 dust collection
holes in the Backing Pad. (There are 4 other
holes in the Backing Pad for screws.)
Functions
clamp
Dust chute
power cord
Switch
Backing
pad
