8
Caution
The dispensed material may be toxic and/or hazardous, refer to material manufacturers bulletin for proper
handling and safety precautions.
1.
Input high pressure air max. shall not excess 7 bar (100psi). Internal air pressure shall not excess 5.5
bar (78psi). If the work pressure is over 4 bar, please use aluminum-alloy connector.
2.
All materials are kept on (50c). Avoid the density changed more, if not, it will be hard to pass, and it
can not do dotting.
3.
The material must be used average/normally, when operated.
4.
Auto mode operation, the air pressure regulated at 1-2.7 bar (15-40 psi) available.
5.
Auto mode operation, clean the material of the tip in order to shot easily.
6.
In “AUTO” mode, the suck-back air force should be adjusted under air pressure, dispensing cycle
and drop size. Too strong air pressure will break the normal work.
7.
When ending work, clean the barrel in time and put the concerned parts in cleaning water for 5-10
minutes, it is easy to clean.
Maintenance
To assure trouble free operation, the following points should be followed:
1.
Make certain air supply is clean and dry.
2.
Make certain AC outlet is grounded and has proper voltage rating.
3.
Avoid turning barrels upside down or laying barrel, so that the material can run through the air line
to internal components.
4.
Do not allow barrel assemblies to be in contact with hot or sharp objects.
5.
Avoid connecting liquid dispenser to air supply exceeding 7 bar (100 psi)
6.
Avoid exposing liquid dispenser to excessive moisture or solvent situation.
Содержание 2000-D
Страница 10: ...10 Dispensing Controller Pneumatic System ...
