07-01810A 2012-10 Warranty 07-00424
7
Dri-Eaz Products, Inc.
6. Clean fuel tank interior
In time, moisture, debris and other impurities may
accumulate in the on-board fuel tank. If these are not
removed, they can be drawn up into the burner and
damage the unit. To clean the tank, follow these steps.
1) Place a drain pan under the fuel drain plug. Remove
the plug and allow the contents to drain out. 2) Replace
the fuel drain plug and add a quart of kerosene to the
tank. Tilt unit back and forth a few times to help dissolve
and suspend any debris that may have accumulated on
the bottom of the tank. Drain out the kerosene and
replace the cap. The unit may now be refueled.
Dispose of contaminated fuel according to state and
local regulations.
7. Cleaning the external housing
To clean the exterior of the Dragon housing, use a
cleaner with a degreasing agent such as ProRestore’s
Degrease-All (ProRestore part no. 161252000).
Service
For parts and service call your local distributor or the
Dri-Eaz Service Department at 800-932-3030 or
360-757-7776. Copies of the Dragon manual and related
information are available at
www.Dri-Eaz.com.
Go to
warranty.Dri-Eaz.com
to register your purchase.
SPECIFICATIONS
Model
Dragon Mobile Furnace F507
Dimensions (W × H × L)
23 × 40 × 55 in.
58 × 102 ×140 cm
Use weight
142 lb. | 64 kg dry
241 lb. | 109 kg full tank
Power
115V, 60 Hz, 5.3 amps
Fuel consumption
1.2 gal/hr | 4.5 L/hr
Fuel type
Diesel fuel oil #2
Kerosene
Fuel tank capacity (on-board)
13.5 gal. | 51.1 L
Rated heat output
130,000 BTU/hr
Process air output
900 CFM | 1530 CMH
Temp. Increase
+144°F | +80°C
Ducting
12 in. × 25 ft.
30 cm × 7.6 m
Specifications are subject to change without notice. Some values may
be approximate.
Accessories Included
1 25 ft. section of 12 in. (7.6 m × 30 cm) high-
temperature ducting. One end is fitted with a cuff and
integrated belt and buckle.
1 Remote thermostat with 40 ft. (12 m) extension cord.
1 Owner’s Manual (07-01810A)
1 Pickup fuel line assembly with threaded tank fitting
(external tank not included)
1 Fuel line conversion kit
SYSTEM INDICATOR TROUBLESHOOTING
I N D I C A T O R
I S S U E
S O L U T I O N
FAILURE
red light
Flame detector fault.
Fuel depleted.
Fuel filter full.
Air in fuel lines at startup.
Clean flame detector. See p. 6.
Refuel.
Replace fuel filter. See p. 6.
Wait 15 seconds and repeat starting sequence. See p. 4.
OVERHEAT
amber light
Unit has overheated. Burner is
off. Fan may be operating.
Ensure adequate airflow through unit.
Ensure ducting is not kinked or collapsed.
Ensure ducting does not exceed 25 ft. (7.6 m) in length.
NOTE: Fan will continue to run until unit is cool.
WORKING
green light
Normal operation.
Unit is operating normally. No action is required.
If the solutions described here do not resolve the problem or the issue you are experiencing is not listed here,
call your local distributor or contact our Service Department toll-free at 800-932-3030 for further assistance.
