07-01712C 2010-10 Warranty 07-00420
4
Dri-Eaz Products, Inc.
Replace only with a new 3M HAF Filter (Dri-Eaz part no.
F369). For parts and service call your local distributor or
contact the Dri-Eaz Service Department at
800-932-3030.
CAUTION:
Dust can cause the unit to overheat and
shut down. Do not operate when excessive dust or
airborne particles are present, such as during
sanding or spray-painting. Inspect and clean air filter
elements and coils frequently.
IMPORTANT: Replace the HAF filter whenever 1)
it has been vacuumed clean 3 times or 2) it has
been used on a mold remediation job or
otherwise exposed to potentially dangerous
contaminants.
Monthly
Check coils
. Dirty coils can
cause the unit to overheat.
Clean when visibly dirty. See
Fig. B.
1. Unplug unit
2. Remove housing, locate
coils and allow coils to dry if
wet.
3. Vacuum both sides of the
coils until clean, being careful
not to let the nozzle touch the
fins; as that may cause
damage by bending them.
Check catch basin tray.
Clean when dirt and debris are
present.
1. Wipe clean with a rag.
Check drain hose.
1. Look for obstructions. Disconnect and clear any debris
present.
2. Reattach gravity drain hose.
Annually
Have the pump system inspected by the Dri-Eaz Service
Department (800-932-3030) or by a qualified service
center.
TRANSPORT AND STORAGE
NOTICE:
Handle the unit carefully. Do not drop,
throw, or place the unit where it could fall. Rough
treatment can damage this equipment and may
create a hazardous condition or
void warranty.
IMPORTANT:
Be sure to purge
the water from the pump reservoir
before moving the unit. See the
PURGE function under "How to
use the control panel" on page 2.
Note that the unit must be
plugged in for the Purge function
to operate.
1. Do not expose the control
panel to moisture, snow or rain
when transporting in uncovered
vehicles.
2. Store and transport securely to
avoid any damaging impact to
internal parts.
READ AND SAVE
THESE INSTR
FIG. B: CLEANING
