49-130B MANUAL, DRITEC 4000i 230V AU
6
Legend Brands, Inc.
TRANSPORTATION AND STORAGE
NOTICE: Handle the unit carefully. Rough treat-
ment can damage this equipment and may create
a hazardous condition or void warranty.
•
Do not expose the control panel to moisture,
snow or rain.
•
Store and transport securely to avoid any dam-
aging impact to internal parts.
•
Secure during transport to prevent sliding and
possible injury to vehicle occupants.
MAINTENANCE
WARNING! ELECTRIC SHOCK HAZARD.
Unplug
unit before cleaning or servicing
.
WARNING: Risk of dust and contaminants expo-
sure. Use of respirator mask and gloves is rec-
ommended. If unit has been exposed to poten-
tially dangerous contaminants, clean thoroughly
and disinfect before reuse.
AS NEEDED (EXTERIOR ITEMS)
Air Filter.
Inspect and vacuum as necessary.
Re-
place the HAF filter whenever it has been vacu-
umed clean and reused three times.
To maintain appearance
, wipe interior and exterior
surfaces with a damp cloth.
Inspect reactivation air outlet ducting for cracks,
splits or breaks. Replace as needed with suitable
heat-resistant ducting.
AS NEEDED (INTERIOR ITEMS) See Fig. D.
NOTICE:
Electric shock hazard. Unplug unit before
removing side panels.
NOTICE:
The unit is fitted with sensitive electronic
sensors. Protect the sensors and their lead wires
from damage and do not expose them to water or
cleaning solution.
The following tools and supplies are needed to com-
plete the maintenance procedures described in this
manual:
•
3 mm Allen wrench and/or bit and cordless drill
•
Clean cloths
•
Vacuum cleaner with soft brush tool and/or a
high pressure air nozzle
Remove side panel.
Remove the screws from the
react out / air inlet panel.
IMPORTANT: The inlet
temp/RH sensor cable is attached to the interior
of the panel and must be detached before setting
the panel aside.
To remove the cable, first unclip
the plug and then slide the cable down and out of the
cable tie. Once the cable is free of the panel, set the
panel aside.
Fig. D: Interior views
Blower
Storage compart-
ment.
React out/air in panel.
Remove this panel
only for routine inte-
rior inspection and
cleaning.
IMPORTANT! Temp/RH
Sensor cable is attached
to inside of panel! Unclip
and slide out of cable tie
before setting panel
aside.
Detach sensor cable be-
fore setting side panel
aside. Be sure to rein-
stall cable when replac-
ing panel.
Desiccant
rotor
React air
outlet
Belt tensioner
(see detail be-
low)
Belt tensioner.
Lift arm upward
to release belt.
