Dreamline UNIDOOR PLUS, Руководство по установке

Страница: 53 / 60

© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Product Maintenance
INLINE PANEL (Style F) Maintenance Checklist
◻ Inspect the U-Channels. Make sure both Bottom and Vertical U-Channels are tightly secured.
◻ Inspect that the Door Glass and Inline Panel glass are properly aligned when the door is in the
closed position.
◻ Inspect the L-Bar™ (for ELEGANCE PLUS models only). Tighten set-screws if necessary.
◻ Inspect and replace damaged or missing Vinyl Seals. Order replacement as necessary to prevent
leakage.
◻ Inspect silicone application. Remove and replace as necessary to prevent leakage. (refer to the
silicone manufacturer’s recommendations on the proper application of their product).
◻ Remove Vinyl Seals to inspect the edges of the glass for concealed damage.
Damaged glass must be replaced!
To maximize the life of your door, it is important to regularly inspect
the glass and other hardware for misalignment, proper attachment,
and/or damage. Contact DreamLine
®
with any questions or concerns.
NOTE
BASES and BACKWALLS : To ensure long lasting life for your acrylic back walls: wipe them off
after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream
based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal
brushes or scrapers that could permanently scratch or dull the surface.
GLASS : To ensure long lasting life for your glass shower products: wipe them off after each use
with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent
soap buildup and water spots (Hard water can etch the surface of the glass over time if left to dry).
To prevent scratching the surface: never use abrasive cleaners or cleaning products that contain
scouring agents. Never use bristle brushes or abrasive sponges that may scratch the surface of the
glass.
HARDWARE : To ensure a long lasting finish: wipe off all metal parts after each use with a soft
cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If
accidentally used, rinse the surface as soon as possible to prevent damage to the finish (peeling or
corrosion). After cleaning the polished finishes, rinse thoroughly and wipe dry with a soft clean-
cloth.
Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or polish
to stainless steel hardware, work with the grain (not across the grain). Never use an abrasive
sponge or cloth, steel wool or wired brush as these may permanently scratch the surfaces.
INLINE PANEL (STYLE F) Glass Installation Manual Ver 2 Rev 1 012020 27
©2020 DreamLine® All Rights Reserved