© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Tools Needed
Hinge Assembly Adjustment Procedure
UNIDOOR MADRID Shower Door and Inline Panel Manual Ver 1 122019
20
© 2019 DreamLine® All Rights Reserved
!
To prevent water leakage, adjust the
Hinge Assemblies (#05)
to overclose so the
Door Glass (#01)
creates a tight seal with the
180° Inline Strike Vinyl (#19)
.
Once the
Door Glass (#01)
is installed:
• Hold the door in the closed position and loosen the set
screws on
both
hinges with the supplied Allen Key
• Move the door to the new desired closed position
• While holding the door in the new closed position, retighten
the set screws on both hinges
•
The Door Glass will now self-center to the new chosen closed
position setting
set screws
NOTE
The Adjustable Hinge Assemblies are
factory to overclose to 85° to create
a tight seal with the Strike Vinyl.
If strike vinyl is not used, the hinges
can be adjusted to close to a different
angle (90° for example).
Overhead view of UNIDOOR
(left-swing installation shown)
wall
wall
wall
wall
wall
outside
outside
inside
inside
85°
90°
wall
Example
The
Hinge Assemblies (#05)
are preset to overclose at 85º for a tight seal against the strike vinyl.
The adjustment feature on the hinge assemblies is used to change the closing angle of the door only.
Remove the
180º Inline Strike Vinyl (#19)
before making any adjustments to the hinges.
Both the top and bottom
Hinge Assemblies (#05)
must be adjusted at the same time and to the same angle
during adjustment.
How to Adjust the Hinge Assemblies
hinges adjusted to overclose
before installing the strike
vinyl seal
Do not adjust the
hinges separately or
before installation.
This could lead to
problems with the
hinges operating
together correctly.
NOTE
