© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
©2018 DreamLine. All Rights Reserved
15
QUATRA PLUS Shower Enclosure Manual Ver 1 10/2018
NOTICE:
Make sure the
Sweep Vinyl (#14)
is flush with the vertical edge on the
Handle
side of the
Door Glass (#02).
door
inside
hinge
panel
Around sweep vinyl
Into the hinge
inside
inside
inside
Into the hinge
Into the hinge
Into the hinge
2
3
4
5
6
1
door
door
door
2
3
4
1
Approx.
3/8”
!
Fig 14
Fig 13
13.
Measure the width at the bottom of the
Door Glass (#02)
to determine the actual glass width.
Using a razor knife, cut the
Sweep Vinyl (#14)
to the size of your measurement and notch
approximately 3/8” off of the inner side of the
Sweep Vinyl (#14)
as shown in
Fig. 13.2
. Press the
Sweep Vinyl (#14)
tightly onto the bottom edge of the
Door Glass (#02).
(Fig 13)
14.
Take three measurements to prepare to notch the
Flanged Anti-Water Strip (#12)
to fit around
the hinges:
• from the top edge of the
Door Glass (#02)
to the upper body
of the top
Hinge (#06)
(+) 7/8”
• from the lower body of the upper
Hinge (#06)
to the upper body
of the bottom
Hinge (#06)
(+) 1-3/4”
• from the lower body of the bottom
Hinge (#06)
to top
of the installed
Sweep Vinyl (#14)
(+) 1-7/8”
Cut the
Hinge Side Vinyl (#13)
according to the measurements.
Notch the cut strips to be able to slide them into the
Hinge (#06)
and around the sweep vinyl to cover
the space to the inline panel glass. Press the cut strips onto the vertical edge of the
Door Glass (#02)
.
(Fig 14)
