RADIO GEAR SETUP
►
The following setup is based on the use of our 4.3g Digital servos (
Part DFFA004
). We have included the
exact measurements needed to recreate our setup if you choose another type of servo; however, don't skimp on
servos for your Alula-TREK! A good quality digital servo with excellent centering will ensure that your Alula-TREK
is a smooth, predictable flyer.
Gather items below:
Transmitter (battery fully charged)
Micro receiver
(2) Servos with servo arms and screws
(Part
DFFA005)
Battery Extension Wire (
Part DFFA013)
4.8V, 300mAh receiver battery (fully charged)
1.
Locate servo arms with two holes on each arm.
Place tiny servo screws in a safe place.
2.
Using small wire clippers, trim away one side of
each servo arm as shown.
3.
Plug Battery Extension Wire into receiver
(observe proper polarity!). This extension wire
replaces a switch and makes it easier to turn on
the glider and charge the battery.
4.
Turn on transmitter and plug battery into female
end of Battery Extension Wire to power up
receiver.
5.
Activate transmitter's Elevon mixing function
(consult your radio manual for details). Elevon
mixing may be referred to as "Delta" mixing on
some transmitter models.
6.
Connect servos to appropriate receiver channels.
Confirm system is bound and servos are
responding smoothly.
7.
Ensure all Trims and Sub-Trims are set to zero,
and all End Points and/or Adjustable Throw
Volumes (ATV) are set to the default of 100%.
3.
